L400 Double Gauge Pod

$65.00

3D Printed in PETG, this gauge pod replaces the port window trim on the door, with gauges oriented towards the driver.

  • Holds 2X 52mm gauges
  • 2X M4 Screws NOT included
  • M4 Riv-nuts NOT included
  • *Some product images have been finished and painted
  • Installation requires 2X M4 riv-nuts and riv-nut tool
  • *Finishing and Painting Required*See our Guide for Painting Parts

Installation Instructions:

  1. Remove the original port window trim with a panel popper (see product images)
  2. Install M4 riv-nuts into the two holes which used to retain the original trim piece
  3. Install gauges into the pod
  4. Run wires into the door and install the populated gauge pod with the supplied hardware

Note: It is recommended to only mount gauges with electronic sending units, as mechanical lines should not be run into the door.

3 in stock

Description

3D Printed in PETG, this gauge pod replaces the port window trim on the door, with gauges oriented towards the driver.

  • Holds 2X 52mm gauges
  • 2X M4 Screws NOT included
  • M4 Riv-nuts NOT included
  • *Some product images have been finished and painted
  • *Finishing and Painting Required*See our Guide for Painting Parts

Installation Instructions:

  1. Remove the original port window trim with a panel popper (see product images)
  2. Install M4 riv-nuts into the two holes which used to retain the original trim piece
  3. Install gauges into the pod
  4. Run wires into the door and install the populated gauge pod with the supplied hardware

Note: It is recommended to only mount gauges with electronic sending units, as mechanical lines should not be run into the door.

 

 

Additional information

Weight .7 lbs
Dimensions 12 × 8 × 6 in

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.